This is a delightful way to gift a friend with 4-5 hand stamped note cards or a gift card. Using one sheet of Designer Series Paper and a few accessories, this little gift will be sure to please. The only adhesive you need are two Mini Glue Dots for the two outside flaps and whatever is necessary to create and attach your outside embellishment.

1. Fold the larger points (6” mark scoring line) toward the middle of the DSP.
2. Then fold the long center scored line into a ‘mountain’ fold, being sure to fold the two fold-overs you just created. Fold the other two score lines into a valley. Pinch the three folds crisply, and then fold the paper closed, like a file folder. 
3. Fold the other two smaller points (4-1/2” score line) toward the ‘outside’ of the paper and secure with single Mini Glue Dots at the points.
4. Using Gold Foil, the Big Shot and the Dashing Deer Thinlit, cut a deer and set aside.
5. Using the Big Shot, die cut the largest circle from a scrap of Very Vanilla cardstock and then run it through the Big Shot using the Swirls & Curls Embossing Folder
6. Scrunch up a long length of Gold Metallic Thread and attach it, using 3-4 Mini Glue Dots, to the Very Vanilla Circle. Then attach the gold deer using Dimensionals.
7. Attach both layers to the flap as shown in the photo. 
8. Attach the 2 small squares (or circles) of Velcro to the inside of the clutch. TIP: Attach the two Velcro pieces to each other, secure one to the front (or back) of the inside of the clutch, close the clutch, lining up the top edges, and then pinch firmly over the Velcro pieces. That will position them in their proper places.

1. Run the 4-1/4” x 3” piece of Very Vanilla cardstock through the Big Shot using the Swirls & Curls Textured Impressions Embossing folder. Attach this layer to the note card on the side that shows the Swirls & Curls “indented” (rather than popping out).
2. Using Very Vanilla cardstock, die cut the third largest circle from the Layering Circles Framelits Dies. Then run that piece through the big shot using the Swirls & Curls Embossing Folder. Set aside.
3. Using the Gold Foil paper, and the third largest Scallop Circle from the Layering Circles Framelits, die cut a circle
4. Attach the Very Vanilla die cut circle (with the popped out Swirls & Curls facing outward) to the Gold Foil scalloped circle. Attach to card front with Stampin’ Dimensionals.
5. Rub the Embossing Buddy over a scrap of Very Vanilla cardstock. Then, using VersaMark ink, stamp the small antlered deer. Sprinkle with Gold Stampin’ Emboss Powder, shake off excess and then set with the Heat Tool.
6. Cut out using the Big Shot and the appropriate die from the Detailed Deer Thinlits Dies. Attach to layered circles with Mini Glue Dots.
7. Attach three of the smallest Pearls to the deer’s neck.
8. Insert card/s and/or a gift card inside the finished clutch as shown in the photo.